There are two ways to open the settings page:
1: In VR, open the Steam Dashboard (menu button on the controller). In the bottom left is a new icon, a small cogwheel. Click on this icon to bring up the OVRMC overlay
2: Go to the install folder and click on "startdesktopmode.bat". This will open OVRMC on your regular desktop.
To set these values, you have to use the desktop mode. Go to the install folder and click on "startdesktopmode.bat".
Note: As of version 0.3.5 you have to restart SteamVR after you set the hotkeys in desktop-mode.
This filter flattens out vibration for rotation.
Values must be between 0 and 1. The number is the rate at which the filter follows a new value. A '1' means immediate adoption of the value. Where a '0' means no adoption.
A low filter-value will filter vibrations better, but you will notice a swimming or lagging picture, as it takes time for the filter to adapt to the real value.
You have to find the sweet spot for your setup.
VR System | Starting Value | Tuning steps |
---|---|---|
Lighthouse based (Pimax, Vive, Index...) | 0.65 | 0.05 |
WMR (HP Reverb...) | 0.85 | 0.10 |
This filter flattens out vibration for translation.
The value has to be a number bigger than 2. There is no upper limit, however a higher value will filter vibrations better, but you will notice a swimming or lagging picture if it is too high. From experience the upper limit is somewhere around 200. This filter also tends to overshoot after a big value change.
VR System | Starting Value | Tuning steps |
---|---|---|
Lighthouse based (Pimax, Vive, Index...) | 50 | 5 |
WMR (HP Reverb...) | 10 | 2 |
Check the FAQ!
No solution found? Contact us!